Lexmark S310 Manuel d'utilisateur télécharger pdf (Page 28)

You can find these WPS logos on the side, back, or top of your access point.

For more information on accessing the wireless settings and determining the WPS capability of your access

point, see the documentation that came with the access point or contact your system support person.

Configuring Wi‑Fi Protected Setup manually

Note: Make sure your access point (wireless router) is Wi‑Fi Protected Setup (WPS) certified. For more

information, see the User’s Guide.

If your printer or device has not yet been configured for wireless connection and you want to configure

it using WPS, then push the WPS button on the wireless router. Wait for the printer control panel to display

a message to begin WPS configuration. There might be a short delay before the message appears. If nothing

happens after 30 seconds, then do one of the following:

USE THE PUSH BUTTON CONFIGURATION (PBC) METHOD

From the printer control panel, navigate to:

> Setup >

> Network Setup >

> Wireless 802.11b/g/n >

> Network Connection

Setup >

> Wireless >

> Wi‑Fi Protected Setup >

> WPS PBC Mode >

2 Follow the instructions on the printer display.

USE THE PERSONAL IDENTIFICATION NUMBER (PIN) METHOD

From the printer control panel, navigate to:

> Setup >

> Network Setup >

> Wireless 802.11b/g/n >

> Network Connection

Setup >

> Wireless >

> Wi‑Fi Protected Setup >

> WPS PIN Mode >

2 Follow the instructions on the printer display.

Wireless networking 28

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 37 38

Pas de commentaire

Lexmark S310 Manuel d'utilisateur Page 28